|
Kto jest w sklepie?
Sklep przegląda 5841 gości i 2 zarejestrowanych klientów
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
(3) (4)
(5)
Adjust the VP (vertical) and the HP (horizontal) position using the 4, buttons. Press the Memory Initialize key of the R/C to store the value in memory. If you do not have this key, short the pins of the 2 pin connector PI1 for one second, then remove. Select PIP mode and shift the sub-picture using the SHIFT button. Distance between PIP and edge of screen should be equal when shifted. if it is not, repeat (i)-(5). Surround Operation Check Adjustment Preparation Input the following audio signals to the audio input of the VIDEO INPUT terminals. When checking surround: L CH: 400Hz sine wave 475mVrms R CH: 5kHz sine wave 475mVrms Set the INT. SPEAKER : ON Set the volume controls of FRONT and REAR to center. Set the BASS, TREBLE and BALANCE to center. Note: Front waveform: Front speaker output of the set. Rear waveform: Rear speaker output of the set. Surround Off Check Set to SURROUND: OFF and check shown below is obtained.
2.5.3 Matrix Surround Check Adjustment Preparation (1) Set to SURROUND : MATRIX Check that the following waveforms are obtained. Front : Check that the phases of R and L are different and 400H.z is superimposed on 5kHz. The amplitudes of R and L are different. Rear : Check that the phases of R and L are opposite and 400Hz is superimposed on SkHz. Front Rear
2.5
O.Sms/div+
0.5ms/div+
2.5.1 (1)
that the waveform 2.5.4 Matrix Surround/Monaural Check Adjustment Preparation Check that the following waveforms are obtained. Front : R and L waveforms are almost equal. Rear : R and L waveforms are almost zero.
Front
@KHz)
Front
Rear
400Hz
(400Hz)
400Hz
OSms/div
Note: REAR output is no signal. 2.5.5 Hall Surround Check Adjustment Preparation (1) Set to SURROUND : HALL. Check that the following waveforms are obtained. Front : Check that the phases of R and L signals are different and 4OOHz is superimposed 5kHz. Rear : Check that the phases of R and L are opposite and 400Hz is superimposed 5kHz. The amplitudes of R and L are equal. Front Rear on
2.5.2 Surround Off/Monaural Check Adjustment Preparation Check that the following waveform is obtained. of 2 channels are equal.
The amplitudes
Front
400Hz
400Hz
Note:
Monaural check can be omitted. REAR output is no signal.
0.5ms/div-t
O.Eims/div+
Note:
Amplitude
levels
of front
R and L are not even.
18
|
|
|
> |
|